When synchronizing with SDI, leave the v-phase to 0 When using an NVIDIA SDI output option and synchronize on blackburst, use the following v-phase settings: Start Viz Config, or open the configuration from Viz Artist (Config button in the upper right corner) To Configure the V-phase Settings when Synchronizing the Card
#POWER MANAGEMENT MODE NVIDIA DRIVER CONTROLLED DRIVERS#
Most recent drivers from NVIDIA already have this setting disabled.įor Quadro FX 4500 SDI, and FX 5500 SDI boards the parameter use_old_nvsdk may need to be set to 1 in the Viz Config file, if stability issues encounter, on unsupported systems. Note that this depends on the driver version used. Unified Back Buffer: Must be disabled (Off) in any case. Off: Used for Viz installations where video is in use (unless used for video walls). Use the 3D application setting: Use for Viz installations (running in Standard PC (VGA) mode) and for Video Wall setups where video is in use. Power Management Modes, difference So after i installed the 368.39 drivers, under Power management modes there are now 5 options instead of 3, and three of those 5 are new to me. In the Global presets drop down box select Workstation App - Dynamic Streaming. Go to Nvidia Control Panel -> Managed 3D Settings -> Power Management Mode. Power management mode: Prefer maximum performance Chart showing the optimal launch angle and spin rate for varying driver ball.
Anisotropic filtering: Application controlledĪntialiasing-Mode: Override any application settings
0 kommentar(er)
